Back

EVS-EN IEC 60444-6:2021

Measurement of quartz crystal unit parameters - Part 6: Measurement of drive level dependence (DLD)

General information
Valid from 15.10.2021
Base Documents
IEC 60444-6:2021; EN IEC 60444-6:2021
Directives or regulations
None

Standard history

Status
Date
Type
Name
15.10.2021
Main
14.11.2013
Main
This part of IEC 60444 applies to the measurements of drive level dependence (DLD) of quartz crystal units. Two test methods (A and C) and one referential method (B) are described. "Method A", based on the π-network according to IEC 60444-5, can be used in the complete frequency range covered by this part of IEC 60444. “Reference Method B”, based on the π-network or reflection method according to IEC 60444-5 or IEC 60444-8 can be used in the complete frequency range covered by this part of IEC 60444. “Method C”, an oscillator method, is suitable for measurements of fundamental mode crystal units in larger quantities with fixed conditions.
NOTE The measurement methods specified in this document are not only applicable to AT-cut, but also to other crystal cuts and vibration modes, such as doubly rotated cuts (IT,SC) and to tuning fork crystal units (by using a high impedance test fixture).
*
*
*
PDF
17.08 € incl tax
Paper
17.08 € incl tax
Browse standard from 2.44 € incl tax
Standard monitoring