Tagasi

EVS-EN 14303:2009+A1:2013

Hoonete tehnoseadmete ja tööstuspaigaldiste soojusisolatsioonitooted. Tehases valmistatud mineraalvillatooted (MW). Spetsifikatsioon

Üldinfo
Kehtetu alates 05.01.2016
Alusdokumendid
EN 14303:2009+A1:2013
Direktiivid või määrused
305/2011 Ehitustooted

Olgugi et standard on tühistatud, on sellel Euroopa Liidu õigusakti 305/2011 mõistes siiski vastavuse eeldus ning vastavust  õigusakti nõuetega saab tagada, kui kasutada standardi tühistatud versiooni. Vastavuse eeldus kehtib, kuni vastav muudatus avaldatakse Euroopa Liidu Teatajas.
 
Uusimat Euroopa Liidu Teatajas avaldatud kooskõlastatud standardite nimekirja saad vaadata siit: 
http://ec.europa.eu/growth/single-market/european-standards/harmonised-standards/

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
05.01.2016
Põhitekst
05.03.2013
Põhitekst + muudatus
Põhitekst
EVS-EN 14303:2009
This European Standard specifies the requirements for factory made mineral wool products, which are used for the thermal insulation of building equipment and industrial installations with an operating temperature range of approximately 0 °C to + 800 °C. NOTE Below an operating temperature of ambient, special means against water vapour diffusion and water accumulation by air flow might be required. Below an operating temperature of - 50 °C, special tests regarding the suitability of the products in the intended application are advised (e.g. liquefaction of oxygen). Manufacturer's advice should be heeded in all cases. The products are manufactured with or without facings or coatings, in the form of rolls, boards, slabs, mats, felts, quilts, wired mats, lamella mats, bevelled lags and pipe sections. This European Standard describes product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling. Products covered by this standard are also used in prefabricated thermal insulation systems and composite panels; the performance of systems incorporating these products is not covered. This European Standard does not specify the required level of a given property that shall be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application can be found in regulations and invitations to tender. Products with a declared thermal conductivity greater than 0,065 W/(m·K) at 10 °C are not covered by this standard. This Eurpean Standard does not cover products for in situ insulation (blowing or pouring) or products for the insulation of the building structure. This European Standard does not cover the following acoustical aspects: direct airborne sound insulation and impact noise transmission index.
*
*
*
PDF
20,74 € koos KM-ga
Paber
20,74 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst + muudatus

EVS-EN 14304:2009+A1:2013

Hoonete tehnoseadmete ja tööstuspaigaldiste soojusisolatsioonitooted. Tehases valmistatud elastsest elastomeervahust tooted (FEF). Spetsifikatsioon
Kehtetu alates 05.01.2016
Põhitekst + muudatus

EVS-EN 14307:2009+A1:2013

Hoonete tehnoseadmete ja tööstuspaigaldiste soojusisolatsioonitooted. Tehases valmistatud pressitud vahtpolüstüreenist tooted (XPS). Spetsifikatsioon
Kehtetu alates 05.01.2016
Põhitekst + muudatus

EVS-EN 14308:2009+A1:2013

Hoonete tehnoseadmete ja tööstuspaigaldiste soojusisolatsioonitooted. Tehases toodetud polüuretaanvahust ja polüisotsüanuraatvahust jäigad tooted. Spetsifikatsioon
Kehtetu alates 05.01.2016
Põhitekst + muudatus

EVS-EN 14309:2009+A1:2013

Hoonete tehnoseadmete ja tööstuspaigaldiste soojusisolatsioonitooted. Tehases valmistatud paisutatud vahtpolüstüreenist tooted (EPS). Spetsifikatsioon
Kehtetu alates 05.01.2016