Tagasi

EVS-EN 1555-3:2010+A1:2012

Plasttorustikusüsteemid gaaskütuste transportimiseks. Polüetüleen (PE). Osa 3: Liitmikud

Üldinfo
Kehtetu alates 20.07.2021
Alusdokumendid
EN 1555-3:2010+A1:2012
Tegevusala (ICS grupid)
23.040.45 Plasttoruliitmikud
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
20.07.2021
Põhitekst
05.12.2012
Põhitekst + muudatus
Põhitekst
EVS-EN 1555-3:2010
This European Standard specifies the characteristics of fusion fittings made from polyethylene (PE) as well as of mechanical fittings for piping systems in the field of the supply of gaseous fuels. It also specifies the test parameters for the test methods referred to in this standard. In conjunction with Parts 1, 2, 4 and 5 of EN 1555, it is applicable to PE fittings, their joints and to joints with components of PE and other materials intended to be used under the following conditions: a) a maximum operating pressure, MOP, up to and including 10 bar 1); b) an operating temperature of 20 °C as reference temperature. NOTE 1 For other operating temperatures, derating coefficients should be used; see EN 1555-5. EN 1555 (all parts) covers a range of maximum operating pressures and gives requirements concerning colours and additives. NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes. This European Standard is applicable for fittings of the following types: c) electrofusion socket fittings; d) electrofusion saddle fittings; e) spigot end fittings (for butt fusion using heated tools and electrofusion socket fusion); f) mechanical fittings. The fittings can e.g. be in the form of couplers, equal and reduced tees, reducers, bends or caps.
*
*
*
PDF
16,70 € koos KM-ga
Paber
16,70 € koos KM-ga
Sirvi standardit: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN 1555-4:2011

Plastics piping systems for the supply of gaseous fuels - Polyethylene (PE) - Part 4: Valves
Kehtetu alates 20.07.2021
Põhitekst + muudatus

EVS-EN 12201-3:2011+A1:2012

Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 3: Fittings
Uusim versioon Kehtiv alates 05.12.2012
Põhitekst

EVS-EN ISO 1452-3 V2:2010

Plastics piping systems for water supply and for buried and above-ground drainage and sewerage under pressure - Unplasticized poly(vinyl chloride) (PVC-U) - Part 3: Fittings
Uusim versioon Kehtiv alates 06.12.2010
Põhitekst

EVS-EN ISO 1452-5:2011

Plastics piping systems for water supply and for buried and above-ground drainage and sewerage under pressure - Unplasticized poly(vinyl chloride) (PVC-U) - Part 5: Fitness for purpose of the system (ISO 1452-5:2009, corrected version 2010-03-01)
Uusim versioon Kehtiv alates 02.06.2011