EVS-EN 300 219 V2.1.1:2016

The present document applies to constant envelope angle modulation systems for use in the land mobile service, using
the available bandwidth, operating on radio frequencies between 30 MHz and 1 GHz, with channel separations of
12,5 kHz, 20 kHz and 25 kHz intended for transmission and/or reception of signals used to initiate a specific response
in the receiver.
Table 1: Radiocommunications service frequency bands
Radiocommunications service frequency bands
Transmit 30 MHz to 1 000 MHz
Receive 30 MHz to 1 000 MHz
The present document applies to non-speech and to the non-speech part of combined speech/non-speech analogue
equipment. In the present document, non-speech radio equipment is defined as a radio equipment transmitting a signal
to initiate a specific response in the receiver. The equipment shall comprise a transmitter and associated encoder and/or
a receiver and associated decoder. The encoder and/or decoder may be a separate piece of equipment, in which case
compliance to the present document covers the encoder and/or decoder in connection with the transmitter and/or
receiver equipment.
In the present document different requirements are given for the different radio frequency bands, channel separations,
environmental conditions and types of equipment, where appropriate.
The types of equipment covered by the present document are as follows:
• Base Station: equipment fitted with an antenna socket;
• Mobile Station: equipment fitted with an antenna socket;
• Handportable stations:
a) fitted with an antenna socket; or
b) without an external antenna socket (integral antenna equipment) but fitted with a permanent internal or a
temporary internal 50 Ω Radio Frequency (RF) connector which allows access to the transmitter output
and the receiver input.
Handportable equipment without an external or internal RF connector and without the possibility of having a temporary
internal 50 Ω RF connector is not covered by the present document. Integral antenna equipment is covered by ETSI
EN 300 341 [i.1] (see the corresponding scope).
The present document contains requirements to demonstrate that "... Radio equipment shall be so constructed that it both
effectively uses and supports the efficient use of radio spectrum in order to avoid harmful interference" and that "....radio
equipment supports certain features ensuring access to emergency services" [i.5].
In addition to the present document, other ENs that specify technical requirements in respect of essential requirements
under other parts of article 3 of the Radio Equipment Directive [i.5] may apply to equipment within the scope of the
present document.