Tagasi

EVS-EN 62329-3-102:2010

Heat shrinkable moulded shapes - Part 3: Specification requirements for shape dimensions, material requirements and compatibility performance - Sheet 102:Heat-shrinkable elastomeric moulded shapes, semi-rigid, material requirements and system performance

Üldinfo
Kehtiv alates 04.11.2010
Alusdokumendid
IEC 62329-3-102:2010; EN 62329-3-102:2010
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
04.11.2010
Põhitekst
This sheet of IEC 62329-3 gives the requirements for heat-shrinkable elastomeric moulded shape, semi-rigid material requirements and system performance. Experience of product performance indicates that this moulded shape material is suitable for inclusion in systems for operation in the following temperature ranges: –75 °C to + 120 °C. The moulded shapes may be supplied with a pre-coated adhesive. Refer to the manufacturers/suppliers for options. A guide to adhesive compatibility is given in Annex A. These moulded shapes are normally supplied in the styles and dimensions given in IEC 62329-3-100. The colour is normally Black. Styles and dimensions other than those specifically listed in IEC 62329-3-100 may be available as custom items. These items shall be considered to comply with this standard if they comply with the property requirements listed in Table 1 with the exception of dimensions. Materials that conform to this specification meet established levels of performance. However, the selection of a material by a user for a specific application should be based on the actual requirements necessary for adequate performance in that application and not based on this specification alone.
*
*
*
PDF
8,86 € koos KM-ga
Paber
8,86 € koos KM-ga
Hind: 2,40 € koos KM-ga
Standardi monitooring