Tagasi

EVS-EN ISO 18119:2018+A1:2021

Gas cylinders - Seamless steel and seamless aluminium-alloy gas cylinders and tubes - Periodic inspection and testing (ISO 18119:2018 + ISO 18119:2018/Amd 1:2021)

Üldinfo
Kehtiv alates 16.09.2021
Alusdokumendid
ISO 18119:2018; EN ISO 18119:2018; ISO 18119:2018/Amd 1:2021; EN ISO 18119:2018/A1:2021
Tegevusala (ICS grupid)
23.020.35 Gaasiballoonid
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
16.09.2021
Põhitekst + muudatus
15.06.2021
Muudatus
02.11.2018
Põhitekst
This document specifies the requirements for periodic inspection and testing to verify the integrity of cylinders and tubes to be re-introduced into service for a further period of time. This document is applicable to seamless steel and seamless aluminium-alloy transportable gas cylinders (single or those that comprise a bundle) intended for compressed and liquefied gases under pressure, of water capacity from 0,5 l up to 150 l and to seamless steel and seamless aluminium-alloy transportable gas tubes (single or those that comprise a bundle) intended for compressed and liquefied gases under pressure, of water capacity greater than 150 l. It also applies, as far as practical, to cylinders of less than 0,5 l water capacity. This document does not apply to the periodic inspection and maintenance of acetylene cylinders or to the periodic inspection and testing of composite cylinders. NOTE Unless noted by exception, the use of the word “cylinder” in this document refers to both cylinders and tubes.
*
*
*
PDF
22,86 € koos KM-ga
Paber
22,86 € koos KM-ga
Hind: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN ISO 11623:2015

Gas cylinders - Composite construction - Periodic inspection and testing (ISO 11623:2015, Corrected version 2017-02)
Uusim versioon Kehtiv alates 05.01.2016
Põhitekst

EVS-EN 14222:2021

Roostevabast terasest auruboilerid
Uusim versioon Kehtiv alates 01.02.2021
Põhitekst

ISO/IEC 17030:2021

Conformity assessment — General requirements for third-party marks of conformity
Uusim versioon Kehtiv alates 09.09.2021