Tagasi

EVS-EN ISO 18595:2007

Resistance welding - Spot welding of aluminium and aluminium alloys - Weldability, welding and testing

Üldinfo
Kehtetu alates 01.03.2021
Alusdokumendid
ISO 18595:2007; EN ISO 18595:2007
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
01.03.2021
Põhitekst
05.12.2007
Põhitekst
This International Standard specifies requirements for resistance spot welding in the fabrication of assemblies of aluminium sheet, extrusions (both work- and age-hardening alloys) and/or cast material comprising two or three thicknesses of metal, where the maximum single (sheet) thickness of components to be welded is within the range 0,6 mm to 6 mm. This International Standard is applicable to the welding of sheets or plates of dissimilar thickness where the thickness ratio is less than or equal to 3:1. It applies to the welding of three thicknesses where the total thickness is less than or equal to 9 mm. Welding with the following types of machines is within the scope of this International Standard:- pedestal welding machines;- gun welders;- automatic welding equipment where the components are fed by robots or automatic feeding equipment;- multi-welders;- robotic welders.
*
*
*
PDF
20,74 € koos KM-ga
Paber
20,74 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring