Tagasi

EVS-EN ISO 2719:2016+A1:2021

Determination of flash point - Pensky-Martens closed cup method (ISO 2719:2016 + ISO 2719:2016/Amd 1:2021)

Üldinfo
Kehtiv alates 03.05.2021
Alusdokumendid
ISO 2719:2016; EN ISO 2719:2016; EN ISO 2719:2016/A1:2021; ISO 2719:2016/Amd 1:2021
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
03.05.2021
Põhitekst + muudatus
15.04.2021
Muudatus
03.08.2016
Põhitekst
This International Standard describes three procedures, A, B and C, using the Pensky-Martens closed cup tester, for determining the flash point of combustible liquids, liquids with suspended solids, liquids that tend to form a surface film under the test conditions, biodiesel and other liquids in the temperature range of 40 °C to 370 °C. CAUTION — For certain mixtures no flash point, as defined, is observed; instead a significant enlargement of the test flame (not halo effect) and a change in colour of the test flame from blue to yellowish-orange can occur. Continued heating can result in significant burning of vapours outside the test cup, and can be a potential fire hazard. NOTE 1 Although, technically, kerosene with a flash point above 40 °C can be tested using this International Standard, it is standard practice to test kerosene according to ISO 13736.[5] Similarly, lubricating oils are normally tested according to ISO 2592[2]. Procedure A is applicable to distillate fuels (diesel, biodiesel blends, heating oil and turbine fuels), new and in-use lubricating oils, paints and varnishes, and other homogeneous liquids not included in the scope of Procedures B or C. Procedure B is applicable to residual fuel oils, cutback residua, used lubricating oils, mixtures of liquids with solids, liquids that tend to form a surface film under test conditions or are of such kinematic viscosity that they are not uniformly heated under the stirring and heating conditions of Procedure A. Procedure C is applicable to fatty acid methyl esters (FAME) as specified in specifications such as EN 14214[11] or ASTM D6751[13]. This International Standard is not applicable to water-borne paints and varnishes. NOTE 2 Water-borne paints and varnishes can be tested using ISO 3679[3]. Liquids containing traces of highly volatile materials can be tested using ISO 1523[1] or ISO 3679.
*
*
*
PDF
16,70 € koos KM-ga
Paber
16,70 € koos KM-ga
Hind: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN ISO 12205:2000

Naftasaadused. Keskmiselt destilleeritud kütuste oksüdatsioonistabiilsuse määramine
Uusim versioon Kehtiv alates 01.01.2000
Põhitekst

EVS-EN ISO 3675:2006

Toornafta ja vedelad naftaproduktid. Laboratoorne tiheduse määramine. Areomeetriline meetod (ISO 3675:1998)
Uusim versioon Kehtiv alates 01.04.2000
Põhitekst

EVS-EN ISO 6245:2003

Naftasaadused. Tuha määramine
Uusim versioon Kehtiv alates 01.03.2003