Tagasi

ISO 14577-4:2007

Metallic materials -- Instrumented indentation test for hardness and materials parameters -- Part 4: Test method for metallic and non-metallic coatings

Üldinfo
Kehtetu alates 26.10.2016
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
26.10.2016
Põhitekst
Põhitekst
ISO 14577-4:2007 specifies a method for testing coatings that is particularly suitable for testing in the nano/micro range applicable to thin coatings. This test method is limited to the examination of single layers when the indentation is carried out normal to the test piece surface, but graded and multilayer coatings can also be measured in cross-section if the thickness of the individual layers or gradations is greater than the spatial resolution of the indentation process. The test method is not limited to any particular type of material. Metallic, non-metallic and organic coatings are included in the scope of ISO 14577-4:2007. The application of ISO 14577-4:2007 regarding measurement of hardness is only possible if the indenter is a pyramid or a cone with a radius of tip curvature small enough for plastic deformation to occur within the coating. The hardness of visco-elastic materials, or materials exhibiting significant creep will be strongly affected by the time taken to perform the test.
*
*
*
PDF
67,10 € koos KM-ga
Paber
67,10 € koos KM-ga
Standardi monitooring