Tagasi

ISO 16889:2022

Hydraulic fluid power — Filters — Multi-pass method for evaluating filtration performance of a filter element

Üldinfo
Kehtiv alates 25.01.2022
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
25.01.2022
Põhitekst
28.11.2018
Muudatus
03.06.2008
Põhitekst
This document describes the following: —    a multi-pass filtration performance test with continuous contaminant injection for hydraulic fluid power filter elements; NOTE 1   For the background interlaboratory study used to verify the test methodology, see Annex D. —    a procedure for determining the contaminant capacity, particulate removal and differential pressure characteristics; —    a test currently applicable to hydraulic fluid power filter elements that exhibit an average filtration ratio greater than or equal to 75 for particle sizes ≥ 25 µm(c), and a final reservoir gravimetric level of less than 200 mg/L; NOTE 2   It is necessary to determine by validation the range of flow rates and the lower particle size limit that can be used in test facilities. —    a test using ISO medium test dust (ISO MTD) contaminant and a test fluid in accordance with Annex A. This document is intended to provide a test procedure that yields reproducible test data for appraising the filtration performance of a hydraulic fluid power filter element without influence of electrostatic charge. This document applies to three test conditions: —    test condition 1, with a base upstream gravimetric level of 3 mg/L; —    test condition 2, with a base upstream gravimetric level of 10 mg/L; —    test condition 3, with a base upstream gravimetric level of 15 mg/L.
*
*
*
PDF
182,80 € koos KM-ga
Paber
182,80 € koos KM-ga
Standardi monitooring