Tagasi

ISO/ASTM 52903-1:2020

Additive manufacturing -- Material extrusion-based additive manufacturing of plastic materials -- Part 1: Feedstock materials

Üldinfo
Kehtiv alates 16.04.2020
Tegevusala (ICS grupid)
25.030 Kihtlisandustootmine
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
16.04.2020
Põhitekst
This document describes a method for defining requirements for plastic materials used in extrusion-based additive manufacturing (AM) processes. Materials include unfilled, filled, and reinforced plastic materials suitable for processing into parts. These materials can also contain special additives (e.g. flame retardants, stabilizers, etc.). Processes include all material extrusion-based AM processes.
This document is intended for use by manufacturers of materials, feedstocks, plastic parts or any combination of the three using material extrusion-based AM.
NOTE       In some cases, material manufacturers can also be feedstock manufacturers. In other cases, a material manufacturer can supply materials (example: pellets) to a feedstock manufacturer (example: converter of pellets into filaments).
This document does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health, and environmental practices and determine the applicability of regulatory limitations prior to use.
*
*
*
PDF
55,07 € koos KM-ga
Paber
55,07 € koos KM-ga
Standardi monitooring