Tagasi

Vabandust – see toode pole enam saadaval

prEN 14870-4

Petroleum and natural gas industries - Induction bends, fittings and flanges for pipeline transportation systems - Part 4: Factory cold bends (ISO 15590-4:2019, modified)

Üldinfo
Kavand
Alusdokumendid
prEN 14870-4; ISO 15590-4:2019
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
Põhitekst
prEN 14870-4
This document specifies the technical delivery conditions for bends made by the cold bending process for bend with radii 5xOD or higher for use in pipeline transportation systems for the petroleum and natural gas industries as defined in ISO 13623. NOTE 1 ISO 13623 is modified adopted as EN 14161 to exclude on-land supply systems used by the European gas supply industry from the input of gas into the on-land transmission network up to the inlet connection of gas appliances. This document also specifies the requirements for the manufacture of two product specification levels (PSLs) of cold bends corresponding to product specification levels given for pipe in ISO 3183. This document is applicable to cold bends made from seamless and welded pipe of unalloyed or low-alloy steels. NOTE 2 These are typically C-Mn steels or low-alloy steels that are appropriate for the corresponding level and grade of line pipe in accordance with ISO 3183. This document is not applicable to the selection of the cold bend product specification level. It is the responsibility of the purchaser to specify the PSL, based upon the intended use and design requirements. NOTE 3 See also ISO 3183:2012, Introduction. This document is not applicable to field cold bends and pipeline bends made by other manufacturing processes. On-land supply systems used by the European gas supply industry from the input of gas into the on-land transmission network up to the inlet connection of gas appliances are excluded from the scope of this document.
*
*
*
PDF
11,59 € koos KM-ga
Paber
11,59 € koos KM-ga
Standardi monitooring