Tagasi

prEN 17468-1

Fibre cement products - Determination of pull through and shear resistance and bending strength calculations - Part 1: Flat sheets

Üldinfo
Kavand
Alusdokumendid
prEN 17468-1
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
Põhitekst
This document specifies a test method for pull through and shear resistance of fibre-cement flat sheets for roofing and cladding. The results are also applicable for: - Coated or uncoated sheets manufactured at the same production facility as the tested sheets. - The test method can be applied to textured or non-textured fibre-cement flat sheets. The results of non-textured sheets are only applicable for textured sheets if the nominal minimum thickness of the textured sheet is at least the nominal thickness of the non-textured sheet. - The same type of fixing head or washer assembly where applicable if the diameter of the fixing head or washer is 0 mm to 2 mm larger than in the test. - The Shore A hardness of the sealing washer, where applicable, is ± 5 that of the washer used in the test. - The diameter of the drilled hole through the fibre cement sheet is 0 mm to 2 mm smaller than in the test, providing there is the required clearance hole around the shank of the fastener. It applies only to products as delivered.
*
*
*
PDF
5,40 € koos KM-ga
Paber
5,40 € koos KM-ga
Standardi monitooring