Tagasi

EVS-EN ISO 11148-7:2012

Käeshoitavad mitteelektrilise ajamiga tööriistad. Ohutusnõuded. Osa 7: Lihv-/lõikemasinad (ISO 11148-7:2012)

Üldinfo
Kehtiv alates 03.10.2012
Alusdokumendid
ISO 11148-7:2012; EN ISO 11148-7:2012
Tegevusala (ICS grupid)
25.140.10 Pneumotööriistad
Direktiivid või määrused
2006/42/EC Masinad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
03.10.2012
Põhitekst
Põhitekst + muudatus
This part of ISO 11148 specifies safety requirements for hand-held non-electric power tools (hereinafter “grinders”) intended for grinding and cutting-off with abrasive products, for use on all kinds of materials. The grinders can be powered by compressed air or hydraulic fluid and are intended to be used by one operator and supported by the operator’s hand or hands, with or without a suspension, e.g. a balancer. NOTE 1 At the time of publication, no grinders driven by internal combustion engines are known (other than cuttingoff machines within the scope of ISO 19432). Once these are identified, it is intended to amend this part of ISO 11148 to include such power tools. This part of ISO 11148 is applicable to grinders used with: - abrasive products with a peripheral operating speed less than or equal to 80 m/s; - cutting-off wheels with a peripheral operating speed less than or equal to 100 m/s; - abrasive products with an outside nominal diameter less than or equal to 230 mm; - cutting-off wheels with an outside nominal diameter less than or equal to 250 mm; - wire brushes; - diamond and reinforced (segmented) wheels with an outside nominal diameter less than or equal to 450 mm; - flap discs and flap wheels.
*
*
*
PDF
28,06 € koos KM-ga
Paber
28,06 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 11148-9:2011

Käeshoitavad mitteelektrilised jõuseadised. Ohutusnõuded. Osa 9: Stantspeenestid (ISO 11148-9:2011)
Uusim versioon Kehtiv alates 04.01.2012
Põhitekst + muudatus

EVS-EN 13218:2002+A1:2008

Tööpingid. Ohutus. Statsionaarsed lihvimismasinad KONSOLIDEERITUD TEKST
Kehtetu alates 05.01.2016
Põhitekst

EVS-EN ISO 11148-8:2011

Käeshoitavad mitteelektrilised jõuseadised. Ohutusnõuded. Osa 8: Lihvijad ja poleerijad (ISO 11148-8:2011)
Uusim versioon Kehtiv alates 04.01.2012
Põhitekst

EVS-EN ISO 11148-3:2012

Käeshoitavad mitteelektrilised jõuseadised. Ohutusnõuded. Osa 3: Puurid ja keermelõikurid
Uusim versioon Kehtiv alates 04.01.2013