Tagasi

EVS-EN ISO 15156-1:2020

Petroleum and natural gas industries - Materials for use in H2S-containing environments in oil and gas production - Part 1: General principles for selection of cracking-resistant materials (ISO 15156-1:2020)

Üldinfo
Kehtiv alates 15.12.2020
Alusdokumendid
ISO 15156-1:2020; EN ISO 15156-1:2020
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
15.12.2020
Põhitekst
06.10.2015
Põhitekst
This document describes general principles and gives requirements and recommendations for the selection and qualification of metallic materials for service in equipment used in oil and gas production and in natural-gas sweetening plants in H2S-containing environments, where the failure of such equipment can pose a risk to the health and safety of the public and personnel or to the environment. It can be applied to help to avoid costly corrosion damage to the equipment itself. It supplements, but does not replace, the materials requirements given in the appropriate design codes, standards, or regulations.
This document addresses all mechanisms of cracking that can be caused by H2S, including sulfide stress cracking, stress corrosion cracking, hydrogen-induced cracking and stepwise cracking, stress-oriented hydrogen-induced cracking, soft zone cracking, and galvanically induced hydrogen stress cracking.
Table 1 provides a non-exhaustive list of equipment to which this document is applicable, including exclusions.
This document applies to the qualification and selection of materials for equipment designed and constructed using load controlled design methods. For design utilizing strain-based design methods, see Clause 5.
This document is not necessarily applicable to equipment used in refining or downstream processes and equipment.
*
*
*
PDF
13,42 € koos KM-ga
PDF redline
17,45 € koos KM-ga
Paber
13,42 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 15156-2:2020

Petroleum and natural gas industries - Materials for use in H2S-containing environments in oil and gas production - Part 2: Cracking-resistant carbon and low-alloy steels, and the use of cast irons (ISO 15156-2:2020)
Uusim versioon Kehtiv alates 15.12.2020
Põhitekst

EVS-EN ISO 15156-3:2020

Petroleum and natural gas industries - Materials for use in H2S-containing environments in oil and gas production - Part 3: Cracking-resistant CRAs (corrosion-resistant alloys) and other alloys (ISO 15156-3:2020)
Uusim versioon Kehtiv alates 15.12.2020
Põhitekst

EVS-EN ISO 4136:2022

Destructive tests on welds in metallic materials - Transverse tensile test (ISO 4136:2022)
Uusim versioon Kehtiv alates 15.06.2022
Põhitekst

EVS-EN ISO 5173:2023

Destructive tests on welds in metallic materials - Bend tests (ISO 5173:2023)
Uusim versioon Kehtiv alates 15.02.2023