Tagasi

EVS-EN ISO 2409:2013

Paints and varnishes - Cross-cut test (ISO 2409:2013)

Üldinfo
Kehtetu alates 02.10.2020
Alusdokumendid
ISO 2409:2013; EN ISO 2409:2013
Tegevusala (ICS grupid)
87.040 Värvid ja lakid
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
02.10.2020
Põhitekst
05.03.2013
Põhitekst
Põhitekst
EVS-EN ISO 2409:2007
This International Standard specifies a test method for assessing the resistance of paint coatings to separation from substrates when a right-angle lattice pattern is cut into the coating, penetrating through to the substrate. The property measured by this empirical test procedure depends, among other factors, on the adhesion of the coating to either the preceding coat or the substrate. This procedure is not to be regarded, however, as a means of measuring adhesion. Where a measurement of adhesion is required, the method described in ISO 4624[1] can be used. NOTE 1 Although the test is primarily intended for use in the laboratory, the test is also suitable for field testing. The method described can be used either as a pass/fail test or, where circumstances are appropriate, as a six-step classification test. When applied to a multi-coat system, assessment of the resistance to separation of individual layers of the coating from each other can be made. The test can be carried out on finished objects and/or on specially prepared test specimens. Although the method is applicable to paint on hard (e.g. metal) and soft (e.g. wood and plaster) substrates, these different substrates need a different test procedure (see Clause 6). The method is not suitable for coatings of total thickness greater than 250 μm or for textured coatings. NOTE 2 The method, when applied to coatings designed to give a rough patterned surface, will give results which will show too much variation (see also ISO 16276‑2[2]).
*
*
*
PDF
13,42 € koos KM-ga
Paber
13,42 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 6272-2:2011

Paints and varnishes - Rapid-deformation (impact resistance) tests - Part 2: Falling-weight test, small-area indenter (ISO 6272-2:2011)
Uusim versioon Kehtiv alates 06.09.2011
Põhitekst

EVS-EN ISO 2813:2014

Paints and varnishes - Determination of gloss value at 20 degrees, 60 degrees and 85 degrees (ISO 2813:2014)
Uusim versioon Kehtiv alates 07.11.2014
Põhitekst

EVS-EN ISO 6272-1:2011

Paints and varnishes - Rapid-deformation (impact resistance) tests - Part 1: Falling-weight test, large-area indenter (ISO 6272- 1:2011)
Uusim versioon Kehtiv alates 06.09.2011
Põhitekst

EVS-EN ISO 3231:2000

Värvid ja lakid. Vastupidavuse määramine vääveldioksiidi sisaldavale niiskusele
Kehtetu alates 01.07.2022