Back

EVS-EN 303 364-3 V1.1.1:2019

Primary Surveillance Radar (PSR); Harmonised Standard for access to radio spectrum; Part 3: Air Traffic Control (ATC) PSR sensors operating in 8 500 MHz to 10 000 MHz frequency band (X band)

General information
Valid from 01.08.2019
Base Documents
ETSI EN 303 364-3 V1.1.1
Directives or regulations
2014/53/EU Radio equipment (RED)
We do not sell ETSI standards on our website. You can download them for no extra charge from here.
Directive 2014/53/EU Notice: As regards clause 4.2.1.4 of this harmonised standard, compliance with this harmonised standard does not confer a presumption of conformity with the essential requirement set out in Article 3(2) of Directive 2014/53/EU to equipment not combining a “WR112/R84 taper section and a WR90/R100 Waveguide” as in note 1 of Section 1 of this harmonised standard. The waveguide is requested to have a continuously unobstructed transmission path (unperturbed/pure) and a minimum length of 20 times the waveguide cut-off wavelength in that operational mode.

Standard history

Status
Date
Type
Name
The present document specifies technical characteristics and methods of measurements for monostatic X-band radar sensors intended for the surveillance of airspace traffic with the following characteristics:
• Operating in the frequency range 8 500 MHz to 10 000 MHz utilizing modulated pulses.
• The transceiver-antenna connection is using a hollow metallic rectangular waveguide.
• The antenna is rotating, waveguide-based and passive.
• At the transceiver output an RF-circulator is used.
NOTE 1: Since transceiver and antenna are hollow metallic rectangular waveguide based the frequency range for measurements that needs to be addressed covers 6,56 GHz to 26 GHz. The lower limit of this frequency range is obtained as cut-off frequency of the combination of WR112/R84 taper section and a WR90/R100 Waveguide IEC 60153-2. The upper limit corresponds to the upper limit stated in Table 1 of ERC Recommendation 74-01.
NOTE 2: Since at the transceiver output an RF circulator is used, it is assumed that the transceiver characteristics remain independent from the antenna.
NOTE 3: Multi-static radars are not covered by the present document.
NOTE 4: The relationship between the present document and essential requirements of article 3.2 of Directive 2014/53/EU is given in annex A.
*
*
*
Standard monitoring