Tagasi

EVS-EN 302 065-3 V2.1.1:2017

Lähitoimeseadmed (SRD), mis kasutavad ultralairiba (UWB) tehnoloogiat; Harmoneeritud standard direktiivi 2014/53/EL artikli 3.2 oluliste nõuete alusel; Osa 3: Nõuded maapealsete sõidukirakenduste UWB seadmetele

Üldinfo
Kehtiv alates 18.04.2017
Alusdokumendid
EN 302 065-3 V2.1.1
Tegevusala (ICS grupid)
33 SIDETEHNIKA
Direktiivid või määrused
2014/53/EU Raadioseadmed
ETSI standardeid meie e-poest osta ei saa. Neid on võimalik tasuta alla laadida siit.
See standard on harmoneeritud standard Direktiivi 2014/53/EL (Raadioseadmed) mõistes, arvestades järgmist märkust: see harmoneeritud standard ei sisalda meetme „saatmine pärast aktiveerimissignaali“ tehnilist kirjeldust. Rakendusotsusega (EL) 2019/785 on aga alates 16. novembrist 2019 kehtestatud tehnilised nõuded, mida tuleb rakendada sagedusalades 3,8–4,2 GHz ja 6–8,5 GHz häirevähendamismeedet „saatmine pärast aktiveerimissignaali“ (i.k trigger-before-transmit) kasutavates sõidukite juurdepääsusüsteemides. Vastavus sellele harmoneeritud standardile ei taga seega vastavust rakendusotsuse (EL) 2019/785 nõuetele ega anna seega alust eeldada vastavust direktiivi 2014/53/EL artikli 3 lõikes 2 sätestatud olulistele nõuetele, mis on seotud häirevähendamismeetmetega „saatmine pärast aktiveerimissignaali“.

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
18.04.2017
Põhitekst
The present document applies to transceivers, transmitters and receivers utilizing Ultra Wide Band (UWB) technologies
and used for short range applications in road and rail vehicles, which includes devices mounted inside or at the surface.
The present document applies to impulse, modified impulse and RF carrier based UWB technologies in the main
operating frequency ranges from 3,1 GHz to 4,8 GHz or from 6 GHz to 9 GHz.
Examples of applications for road and rail vehicles are:
• stand-alone radio equipment with or without its own control provisions;
• plug-in radio devices intended for use with, or within, a variety of host systems, e.g. personal computers, etc.;
• plug-in radio devices intended for use within combined equipment, e.g. modems, access points, etc.;
• equipment for telemetry communication inside and outside of road and rail vehicles;
• equipment for the localization of devices inside and outside of road and rail vehicles (e.g. hand-held devices);
• equipment to investigate materials (e.g. fuel).
The present document does not apply to fixed road infrastructure installations. For fixed rail infrastructure tracking
applications see ETSI TR 101 538 [i.10] and ETSI TS 103 085 [i.11].
NOTE: As per the ECC/DEC/(06)04 [i.2] and Decision 2014/702/EC [i.4] the UWB transmitter equipment
conforming to the present document is not to be installed at a fixed outdoor location, for use in flying
models, aircraft and other forms of aviation. The present document applies to UWB equipment with an
output connection used with a dedicated antenna or UWB equipment with an integral antenna.
Equipment covered by the present document operates in accordance with ECC/DEC(06)04 [i.2].
These radio equipment types are capable of operating in all or part of the frequency bands given in table 1.
Table 1: Permitted range and intended range of operation [i.4]
Permitted range of operation (note 1)
Transmit 30 MHz to 10,6 GHz
Receive 30 MHz to 10,6 GHz
Intended ranges of operation (note 2)
Transmit 3,1 GHz to 4,8 GHz
Receive 3,1 GHz to 4,8 GHz
Transmit 6,0 GHz to 9 GHz
Receive 6,0 GHz to 9 GHz
NOTE 1: Limits in table 2, clause 4.3.2 and table 3, clause 4.3.3 are to be met.
NOTE 2: This is the preferred range for the operating bandwidth, as defined in clause 4.3.1.
The present document does not apply to radio equipment for which a specific Harmonised EN applies as such.
Harmonised EN may specify additional EN requirements relevant to the presumption of conformity under article 3.2 of
the Radio Equipment Directive (Directive 2014/53/EU) [i.1].
*
*
*
Standardi monitooring