Skip to main content
Tagasi

EVS-EN ISO 14577-4:2016

Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 4: Test method for metallic and non-metallic coatings (ISO 14577-4:2016)

Üldinfo

Kehtiv alates 03.01.2017
Alusdokumendid
ISO 14577-4:2016; EN ISO 14577-4:2016
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
03.01.2017
Põhitekst
04.07.2007
Põhitekst
ISO 14577-4:2016 specifies a method for testing coatings which is particularly suitable for testing in the nano/micro range applicable to thin coatings. However, the application of this method of this part of ISO 14577 is not needed if the indentation depth is such a small fraction of the coating thickness that in any possible case a substrate influence can be neglected and the coating can be considered as a bulk material. Limits for such cases are given.
This test method is limited to the examination of single layers when the indentation is carried out normal to the test piece surface, but graded and multilayer coatings can also be measured in cross-section if the thickness of the individual layers or gradations is greater than the spatial resolution of the indentation process.
The test method is not limited to any particular type of material. Metallic and non-metallic coatings are included in the scope of this part of ISO 14577. In this part of ISO 14577, the term coating is used to refer to any solid layer with homogeneous properties different to that of a substrate it is connected to. The method assumes that coating properties are constant with indentation depth. Composite coatings are considered to be homogenous if the structure size is less than the indentation size.
The application of this part of ISO 14577 regarding measurement of indentation hardness is only possible if the indenter is a pyramid or a cone with a radius of tip curvature small enough for plastic deformation to occur within the coating. The hardness of visco-elastic materials or materials exhibiting significant creep will be strongly affected by the time taken to perform the test.

Nõutud väljad on tähistatud *

*
*
*
PDF
19,52 € koos KM-ga
Paber
19,52 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 14577-2:2015

Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 2: Verification and calibration of testing machines (ISO 14577-2:2015)
Uusim versioon Kehtiv alates 02.09.2015
Põhitekst

EVS-EN ISO 14577-3:2015

Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 3: Calibration of reference blocks (ISO 14577-3:2015)
Uusim versioon Kehtiv alates 02.09.2015
Põhitekst

EVS-EN ISO 7405:2018

Dentistry - Evaluation of biocompatibility of medical devices used in dentistry (ISO 7405:2018, Corrected version 2018-12)
Uusim versioon Kehtiv alates 19.12.2018
Põhitekst

EVS-EN ISO 17637:2016

Keevisõmbluste mittepurustav kontroll. Sulakeevitusliidete visuaalne kontroll
Uusim versioon Kehtiv alates 03.01.2017