Skip to main content
Tagasi

EVS-EN ISO 15156-1:2015

Petroleum and natural gas industries - Materials for use in H2S-containing environments in oil and gas production - Part 1: General principles for selection of cracking-resistant materials (ISO 15156-1:2015)

Üldinfo

Kehtetu alates 15.12.2020
Alusdokumendid
ISO 15156-1:2015; EN ISO 15156-1:2015
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
15.12.2020
Põhitekst
06.10.2015
Põhitekst
06.01.2010
Põhitekst
EVS-EN ISO 15156-1:2009
This part of ISO 15156 describes general principles and gives requirements and recommendations for the selection and qualification of metallic materials for service in equipment used in oil and gas production and in natural-gas sweetening plants in H2S-containing environments, where the failure of such equipment can pose a risk to the health and safety of the public and personnel or to the environment. It can be applied to help to avoid costly corrosion damage to the equipment itself. It supplements, but does not replace, the materials requirements given in the appropriate design codes, standards, or regulations.
This part of ISO 15156 addresses all mechanisms of cracking that can be caused by H2S, including sulfide stress cracking, stress corrosion cracking, hydrogen-induced cracking and stepwise cracking, stress-oriented hydrogen-induced cracking, soft zone cracking, and galvanically induced hydrogen stress cracking.

Nõutud väljad on tähistatud *

*
*
*
PDF
15,86 € koos KM-ga
Paber
15,86 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 15156-2:2015

Petroleum and natural gas industries - Materials for use in H2S-containing environments in oil and gas production - Part 2: Cracking-resistant carbon and low alloy steels, and the use of cast irons (ISO 15156-2:2015)
Kehtetu alates 15.12.2020
Põhitekst

EVS-EN ISO 15156-3:2015

Petroleum and natural gas industries - Materials for use in H2S-containing environments in oil and gas production - Part 3: Cracking-resistant CRAs (corrosion-resistant alloys) and other alloys (ISO 15156-3:2015)
Kehtetu alates 15.12.2020
Põhitekst

EVS-EN ISO 6506-4:2014

Metallic materials - Brinell hardness test - Part 4: Table of hardness values (ISO 6506-4:2014)
Uusim versioon Kehtiv alates 07.11.2014
Põhitekst

EVS-EN ISO 6508-2:2015

Metallic materials - Rockwell hardness test - Part 2: Verification and calibration of testing machines and indenters (ISO 6508-2:2015)
Kehtetu alates 29.12.2023