Skip to main content
Back

prEN IEC 63407:2024

Conductive charging of electric vehicles - Contact interface for automated connection device (ACD)

General information

Draft
Base Documents
23H/561/CDV; prEN IEC 63407:2024
Directives or regulations
None
You can view draft standards in the Commenting portal🡭.

Standard history

Status
Date
Type
Name
This document is applicable to automatic couplers of standardized configuration, intended for use in electric vehicle conductive charging systems which incorporate control means, with rated operating voltage up to 1 500 V DC.
This document applies to high power DC interfaces intended for use in isolated conductive charging systems,
for circuits specified in IEC 61851-23-1.
The requirements of this standard applies only to automatic couplers defined in the annexes A, B, C and D of this document.
The ACDs covered by this document are used only in charging mode 4, according to IEC 61851-23-1,  3.1.201 Case D or 3.1.202 Case E.
This document describes the requirements for an automatic couplers in regard of safety, function and testing.
This document describes basic parameters that can be standardized for different automatic couplers s.
Automatic couplers s following these standardized parameters will have the benefit of being compatible, even if they are based on different technologies.
This document does not apply to solutions based on a vehicle connector described in IEC 62196-3 and IEC TS63379 driven by an automatic mechanism, as, for instance, a robotic arm.
This document does not apply to systems described in IEC 61851-26.
This document does not cover all safety aspects related to maintenance.

Required fields are indicated with *

*
*
*
Standard monitoring