1.0 General The present document specifies technical characteristics and methods of measurements for the following equipment:
• Aerial User Equipment (UE) for Evolved Universal Terrestrial Radio Access (E-UTRA) and New Radio (NR).
NOTE: The relationship between the present document and essential requirements of Directive 2014/53/EU is given in annex A.
1.1 Operating bands The aerial UE is capable of operating in all, or any part of the E-UTRA and NR frequency bands given in Table 1.1-1.
Table 1.1-1: E-UTRA and NR aerial UE operating bands
Band designation for operation as: E-UTRA; NR; Uplink (UL) operating band aerial UE transmit FUL_low to FUL_high; Downlink (DL) operating band aerial UE receive FDL_low to FDL_high; Duplex Mode;
1; n1; 1 920 MHz to 1 980 MHz; 2 110 MHz to 2 170 MHz; FDD;
3; n3; 1 710 MHz to 1 785 MHz; 1 805 MHz to 1 880 MHz; FDD;
7 (see note 3); n7 (see note 3); 2 500 MHz to 2 570 MHz; 2 620 MHz to 2 690 MHz; FDD;
8; n8; 880 MHz to 915 MHz; 925 MHz to 960 MHz; FDD;
20 (see note 3); n20 (see note 3); 832 MHz to 862 MHz; 791 MHz to 821 MHz; FDD;
28 (see notes 1 and 3); n28 (see notes 1 and 3); 703 MHz to 748 MHz; 758 MHz to 803 MHz; FDD;
38 (see note 3; n38 (see note 3); 2 570 MHz to 2 620 MHz; 2 570 MHz to 2 620 MHz; TDD;
N/A; n91 (see notes 2 and 3); 832 MHz to 862 MHz; 1 427 MHz to 1 432 MHz; FDD;
N/A; n92 (see notes 2 and 3); 832 MHz to 862 MHz; 1 432 MHz to 1 517 MHz; FDD;
N/A; n93 (see note 2); 880 MHz to 915 MHz; 1 427 MHz to 1 432 MHz; FDD;
N/A; n94 (see note 2); 880 MHz to 915 MHz; 1 432 MHz to 1 517 MHz; FDD;
N/A; n109 (see notes 2 and 3); 703 MHz to 733 MHz; 1 432 MHz to 1 517 MHz; FDD;
NOTE 1: In Europe, according to Commission Implementing Decision (EU) 2016/687 of 28 April 2016 and ECC Decision (15)01, radio equipment in band 28 is only allowed between 703 MHz and 736 MHz (FUL_low = 703 MHz and FUL_high = 736 MHz) for the transmitter and between 758 MHz and 791 MHz (FDL_low = 758 MHz and FDL_high = 791 MHz) for the receiver.
NOTE 2: Variable duplex operation does not enable dynamic variable duplex configuration by the network, and is used such that DL and UL frequency ranges are supported independently in any valid frequency range for the band.
NOTE 3: For those bands, mechanisms to ensure no-transmit zones for the aerial UEs are not considered in the current version of the present document.
NOTE: The relationship between the present document and essential requirements of article 3.2 of Directive 2014/53/EU is given in annex A.
The present document covers requirements for E-UTRA and NR aerial UE from 3GPP™ Releases 18 defined in ETSI TS 136 101 and ETSI TS 138 101-1, respectively. This includes the requirements for E-UTRA and NR aerial UE operating bands from 3GPP™ Release 18 defined in ETSI TS 136 101 and ETSI TS 138 101-1.
The requirements for NR aerial UE in the present document apply to the combination of channel bandwidths, SCS and operating bands shown in Table 1.1-2. The channel bandwidths are specified for both the TX and RX path.
Table 1.1-2: Channel Bandwidths for each NR band
NR band / SCS / UE Channel bandwidth;
NR Band; SCS kHz; 5 MHz; 10 MHz (notes 1, 2); 15 MHz (note 2); 20 MHz (note 2); 25 MHz (note 2); 30 MHz; 35 MHz; 40 MHz; 45 MHz; 50 MHz
NOTE 1: 90 % spectrum utilization may not be achieved for 30 kHz SCS. NOTE 2: 90 % spectrum utilization may not be achieved for 60 kHz SCS. NOTE 3: This aerial UE channel bandwidth applies only to downlink. NOTE 4: This aerial UE channel bandwidth is optional in this version of the present document.
NOTE 5: For the 20 MHz bandwidth, the minimum requirements are specified for NR UL carrier frequencies confined to either 713 MHz to 723 MHz or 728 MHz to 738 MHz.
NOTE 6: This aerial UE channel bandwidth is applicable only to uplink.
Required fields are indicated with *
