Infoteenus
17.040.40 Toote geomeetriline spetsifikatsioon (GPS)
Uued standardid
EVS-EN ISO 10360-102:2026
Geometrical product specifications (GPS) - Acceptance and reverification tests for coordinate measuring systems (CMS) - Part 102: Grammar of symbols for metrological characteristics and their specifications (ISO 10360-102:2026)
Käsitlusala: This document specifies the grammar of symbols used in ISO 10360 series in order to identify metrological characteristics of coordinate measuring systems (CMSs) and their specifications.
This document does not provide the meaning of these symbols, neither of whole symbols nor of their components. These meanings are specified in the ISO 10360 documents introducing them.
This document does not provide the meaning of these symbols, neither of whole symbols nor of their components. These meanings are specified in the ISO 10360 documents introducing them.
Alusdokumendid: ISO 10360-102:2026; EN ISO 10360-102:2026
ISO 582:2026
Rolling bearings — Chamfer dimensions — Geometrical product specifications (GPS) and values
Käsitlusala: This document specifies the chamfer least material boundary for ring and washer chamfers of metric series rolling bearings for the corresponding radius maximum material boundaries. The radius maximum material boundaries are given in references[1],[2],[3],[4],[5],[6],[7].
Recommendations are given for the corresponding housing and shaft fillet radii.
Recommendations are given for the corresponding housing and shaft fillet radii.
Alusdokumendid:
ISO 16610-22:2026
Geometrical product specifications (GPS) — Filtration — Part 22: Linear profile filters: Spline filters
Käsitlusala: This document specifies linear spline filters for the filtration of surface profiles. It defines, in particular, how to separate large- and small-scale lateral components of surface profiles.
The concepts presented for closed profiles are applicable to the case of roundness filtration. Where appropriate, these concepts can be extended to generalized closed profiles, especially for surface profiles with re-entrant features.
Examples for the application of the spline filter are given in Annex A. The influence of the tension parameter on the large-scale lateral component of the profile is shown in Annex B.
The concepts presented for closed profiles are applicable to the case of roundness filtration. Where appropriate, these concepts can be extended to generalized closed profiles, especially for surface profiles with re-entrant features.
Examples for the application of the spline filter are given in Annex A. The influence of the tension parameter on the large-scale lateral component of the profile is shown in Annex B.
Alusdokumendid:
Asendab: ISO 16610-22:2015
Asendatud standardid
Kavandid
prEN ISO 25178-6
Geometrical product specifications (GPS) - Surface texture: Areal - Part 6: Classification of methods for measuring surface topography (ISO/DIS 25178-6:2026)
Käsitlusala: ISO 25178-6:2010 describes a classification system for methods used primarily for the measurement of surface texture. It defines three classes of methods, illustrates the relationships between the classes, and briefly describes specific methods.
Alusdokumendid: ISO/DIS 25178-6; prEN ISO 25178-6