This part of IEC 60034 specifies the factory acceptance vibration test procedures and vibration limits for certain electrical machines under specified conditions, when uncoupled from any load or prime mover.
It is applicable to DC and three-phase AC machines, with shaft heights 56 mm and higher and a rated output up to 50 MW, at operational speeds from 120 min–1 up to and including 15 000 min–1.
This document is not applicable to machines mounted in situ (on site), three-phase commutator motors, single-phase machines, three-phase machines operated on single-phase systems, vertical waterpower generators, turbine generators greater than 20 MW and machines with magnetic bearings or series-wound machines.
NOTE 1 For machines measured in situ, refer to applicable parts of ISO 20816-1 and ISO 20816-3.
NOTE 2 For output power above 50 MW reference shall be made to ISO 20816 standards.
NOTE 3 Vibration routine tests are not mandatory according to IEC 60034-1. If performed the method for testing is included in this standard.
Required fields are indicated with *
