Back

ISO 286-2:2010

Geometrical product specifications (GPS) -- ISO code system for tolerances on linear sizes -- Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts

General information
Valid from 07.06.2010
Directives or regulations
None

Standard history

Status
Date
Type
Name
26.07.2013
Corrigendum
07.06.2010
Main
ISO 286-2:2010 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. ISO 286-2 covers values for the upper limit deviations eU, hole (for holes) and eU, shaft (for shafts) and the lower limit deviations eL, hole (for holes) and eL, shaft (for shafts).
The ISO system for tolerances on linear size provides a system of tolerances and deviations suitable for features of the following types:
cylinders;
two parallel opposite surfaces.
For simplicity, and also because of the importance of cylindrical workpieces of circular section, only these are referred to explicitly. It should be clearly understood, however, that the tolerances and deviations given in ISO 286-2 equally apply to workpieces of other than circular sections.
*
*
*
PDF
254.36 € incl tax
Paper
254.36 € incl tax
Standard monitoring

Customers who bought this item also bought

Main + corrigendum

EVS-EN ISO 286-1:2010

Geometrical product specifications (GPS) - ISO code system for tolerances of linear sizes - Part 1: Basis of tolerances, deviations and fits (ISO 286-1:2010)
Newest version Valid from 06.07.2010
Main

EVS-EN 22768-2:2007

General tolerances - Part 2: Geometrical tolerances for features without individual tolerance indications (ISO 2768-2:1989)
Withdrawn from 15.03.2021