Tagasi

EVS-EN 1071-6:2007

Advanced technical ceramics - Methods of test for ceramic coatings - Part 6: Determination of the abrasion resistance of coatings by a micro-abrasion wear test

Üldinfo
Kehtetu alates 03.05.2016
Alusdokumendid
EN 1071-6:2007
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
03.05.2016
Põhitekst
08.01.2008
Põhitekst
This part of EN 1071 specifies a method for measuring the abrasive wear rate of ceramic coatings by means of a micro-scale abrasion wear test, based on the well known crater grinding technique used for film thickness determination (see EN 1071-2). This method can provide data on both film and substrate wear rates, either by performing two separate tests or by careful analysis of data from a single test series. The test method can be applied to samples with planar or non-planar surfaces but the analysis described in clause 9 applies only to flat samples. For non-planar samples, a more complicated analysis, possibly requiring the use of numerical methods, is required
*
*
*
PDF
13,08 € koos KM-ga
Paber
13,08 € koos KM-ga
Sirvi standardit: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN 1071-12:2010

Advanced technical ceramics - Methods of test for ceramic coatings - Part 12: Reciprocating wear test
Uusim versioon Kehtiv alates 07.06.2010
Põhitekst

EVS-EN 1071-13:2010

Advanced technical ceramics - Methods of test for ceramic coatings - Part 13: Determination of wear rate by the pin-on-disk method
Uusim versioon Kehtiv alates 07.06.2010
Põhitekst

EVS-EN 1071-3:2005

Advanced technical ceramics - Methods of test for ceramic coatings - Part 3: Determination of adhesion and other mechanical failure modes by a scratch test
Kehtetu alates 03.05.2016