Skip to main content
Tagasi

EVS-EN 13523-7:2021

Coil coated metals - Test methods - Part 7: Resistance to cracking on bending (T-bend test)

Üldinfo

Kehtiv alates 01.11.2021
Alusdokumendid
EN 13523-7:2021
Tegevusala (ICS grupid)
25.220.60 Orgaanilised pinded
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
01.11.2021
Põhitekst
04.08.2014
Põhitekst
This document specifies the procedure for determining the resistance to cracking of an organic coating on a metallic substrate when bent through 135° to 180°. The degree of adhesion can also be evaluated.
Both folding and mandrel methods are considered. The folding method is more often used for practical purposes but where more precise determinations are required, the mandrel method is the preferred method.
The cylindrical bend method can also be used for a pass/fail decision by using an agreed mandrel.
The choice of the appropriate test method is limited by the thickness and/or the hardness of the substrate.
The feasibility of the test depends on the type and thickness of the substrate. During the procedure, the mandrel is not intended to deform.

Nõutud väljad on tähistatud *

*
*
*
*
PDF
16,12 € koos KM-ga
Paber
16,12 € koos KM-ga
Sirvi standardit alates 2,48 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN 13523-4:2014

Coil coated metals - Test methods - Part 4: Pencil hardness
Uusim versioon Kehtiv alates 03.09.2014
Põhitekst

EVS-EN 13523-5:2014

Coil coated metals - Test methods - Part 5: Resistance to rapid deformation (impact test)
Uusim versioon Kehtiv alates 04.08.2014
Põhitekst

EVS-EN ISO 2813:2014

Paints and varnishes - Determination of gloss value at 20 degrees, 60 degrees and 85 degrees (ISO 2813:2014)
Uusim versioon Kehtiv alates 07.11.2014
Põhitekst

EVS-EN 13523-10:2017

Coil coated metals - Test methods - Part 10: Resistance to fluorescent UV radiation and water condensation
Kehtetu alates 02.05.2024