Tagasi

EVS-EN 17333-3:2020

Characterisation of one component foam - Part 3: Application

Üldinfo
Kehtiv alates 02.04.2020
Alusdokumendid
EN 17333-3:2020
Tegevusala (ICS grupid)
83.180 Liimid
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
02.04.2020
Põhitekst
This document specifies test methods for the evaluation of the application properties for moisture curing, self-curing activatable or water drying foams dispensed from single pressurized foam containers. This document does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this document to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. The following test methods are described: - Method 1 - Cutting time: This test method describes how to determine the hardening time of a dispended froth until it could be cut. - Method 2 - Tack free time: This test method describes how to determine the tack free time of a freshly foamed OCF. - Method 3 - Sagging: This test method describes how to evaluate the sagging behaviour and determine the biggest joint possible before dispensed froth slips off.
*
*
*
PDF
11,39 € koos KM-ga
Paber
11,39 € koos KM-ga
Hind: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN 17333-1:2020

Characterisation of one component foam - Part 1: Foam yield characteristics
Uusim versioon Kehtiv alates 02.04.2020
Põhitekst

EVS-EN 17333-2:2020

Characterisation of one component foam - Part 2: Expansion characteristics
Uusim versioon Kehtiv alates 02.04.2020
Põhitekst

EVS-EN 17333-4:2020

Characterisation of one component foam - Part 4: Mechanical strength
Uusim versioon Kehtiv alates 02.04.2020
Põhitekst

EVS-EN 17333-5:2020

Characterisation of one component foam - Part 5: Insulation
Uusim versioon Kehtiv alates 02.04.2020