Tagasi

EVS-EN 485-1:2016

Aluminium and aluminium alloys - Sheet, strip and plate - Part 1: Technical conditions for inspection and delivery

Üldinfo
Kehtiv alates 05.09.2016
Alusdokumendid
EN 485-1:2016
Tegevusala (ICS grupid)
77.150.10 Alumiiniumtooted
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
05.09.2016
Põhitekst
06.01.2010
Põhitekst + muudatus
This document specifies the technical conditions for inspection and delivery of wrought aluminium and wrought aluminium alloy sheet, strip and plate for general applications. It also includes provisions for ordering and testing. It applies to products with a thickness over 0,20 mm up to and including 400 mm. For many special applications of aluminium strip, sheet and plate, specific European Standards exist, where different or additional requirements are formulated and the appropriate alloys and tempers are selected: see Annex A. Most of these special European Standards refer to provisions of this document. The selection of the relevant special European Standards is under the responsibility of the purchaser. Whenever the application involves special properties, such as corrosion resistance, toughness, fatigue strength, surface appearance and welding properties, the user should consult the supplier and consider the relevant special European Standard, as applicable.
*
*
*
PDF
12,23 € koos KM-ga
Paber
12,23 € koos KM-ga
Hind: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN 485-2:2016

Aluminium and aluminium alloys - Sheet, strip and plate - Part 2: Mechanical properties
Kehtetu alates 02.11.2018
Põhitekst

EVS-EN 485-4:2000

Alumiinium ja alumiiniumisulamid. Lehed, ribad ja plaadid. Osa 4: Külmvaltstoodete mõõtmetolerantsid ja kuju lubatud piirhälbed
Uusim versioon Kehtiv alates 01.01.2000
Põhitekst + muudatus

EVS-EN 485-2:2016+A1:2018

Aluminium and aluminium alloys - Sheet, strip and plate - Part 2: Mechanical properties
Uusim versioon Kehtiv alates 02.11.2018
Põhitekst

EVS-EN 485-3:2003

Alumiinium ja alumiiniumisulamid. Lehed, ribad ja plaadid. Osa 3: Kuumvaltstoodete mõõtmetolerantsid ja kuju lubatud piirhälbed
Uusim versioon Kehtiv alates 01.05.2003