Tagasi

EVS-EN 60317-0-1:2014

Specifications for particular types of winding wires -- Part 0-1: General requirements - Enamelled round copper wire

Üldinfo
Kehtiv alates 04.02.2014
Alusdokumendid
IEC 60317-0-1:2013; EN 60317-0-1:2014
Tegevusala (ICS grupid)
29.060.10 Elektrijuhid
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
01.11.2019
Muudatus
04.02.2014
Põhitekst
07.08.2008
Põhitekst
IEC 60317-0-1:2013 specifies general requirements of enamelled round copper winding wires with or without bonding layer. The range of nominal conductor diameters is given in the relevant specification sheet. This fourth edition cancels and replaces the third edition published in 2008. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:
- revision to the definition of nominal conductor dimension;
- new subclause containing general notes on winding wire, formerly a part of the scope;
- revision to elongation requirements in Table 4;
- revisions to Clause 13, Breakdown voltage, to include new requirements for intermediate wire diameters;
- revision to continuity of insulation requirements in Table 13;
- revision to the introduction of Annex A;
- revision to B.2 of Annex B;
- revision to Table C.1 of Annex C. Keywords: requirements of enamelled round copper winding wires
*
*
*
PDF
20,74 € koos KM-ga
Paber
20,74 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN 60851-5:2008

Winding wires - Test methods -- Part 5: Electrical properties
Uusim versioon Kehtiv alates 05.12.2008
Muudatus

EVS-EN 60317-0-1:2014/A1:2019

Specifications for particular types of winding wires - Part 0-1: General requirements - Enamelled round copper wire
Uusim versioon Kehtiv alates 01.11.2019
Muudatus

EVS-EN 60851-3:2009/A2:2019

Winding wires - Test methods - Part 3: Mechanical properties
Kehtetu alates 16.10.2023
Muudatus

EVS-EN 60851-2:2010/A2:2019

Winding wires - Test methods - Part 2: Determination of dimensions
Uusim versioon Kehtiv alates 01.08.2019