Tagasi

EVS-EN 6041:2018

Aerospace series - Non-metallic materials - Test method - Analysis of non-metallic materials (uncured) by Differential Scanning Calorimetry (DSC)

Üldinfo
Kehtiv alates 01.02.2018
Alusdokumendid
EN 6041:2018
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
01.02.2018
Põhitekst
This test method defines the procedure for the determination of the curing-characteristic and glass transition temperature of non-metallic materials (e.g. preimpregnated and neat resin systems, adhesives) for aerospace use by Differential Scanning Calorimetry (DSC).
The results obtained by this method may be useful for:
-  derivation of the optimum cure cycle (only together with other test methods e.g. Tg determination)
-  assessment of the condition of the resin
-  assessment of the ageing behavior of the resin
This European Standard does not give any directions necessary to meet the health and safety requirements. It is the responsibility of the user of this European Standard to adopt appropriate health and safety precautions.
*
*
*
PDF
13,42 € koos KM-ga
Paber
13,42 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN 6064:2017

Aerospace series - Analysis of non-metallic materials (cured) for the determination of the extent of cure by Differential Scanning Calorimetry (DSC)
Uusim versioon Kehtiv alates 02.01.2018
Põhitekst

EVS-EN 6038:2015

Aerospace series - Fibre reinforced plastics - Test method - Determination of the compression strength after impact
Uusim versioon Kehtiv alates 05.01.2016
Põhitekst

EVS-EN ISO 2555:2018

Plastics - Resins in the liquid state or as emulsions or dispersions - Determination of apparent viscosity using a single cylinder type rotational viscometer method (ISO 2555:2018)
Uusim versioon Kehtiv alates 04.07.2018
Põhitekst

EVS-EN ISO 11357-3:2018

Plastics - Differential scanning calorimetry (DSC) - Part 3: Determination of temperature and enthalpy of melting and crystallization (ISO 11357-3:2018)
Uusim versioon Kehtiv alates 16.05.2018