Tagasi

EVS-EN 74-2:2008

Couplers, spigot pins and baseplates for use in falsework and scaffolds - Part 2: Special couplers - Requirements and test procedures

Üldinfo
Kehtetu alates 18.04.2022
Alusdokumendid
EN 74-2:2008
Tegevusala (ICS grupid)
91.220 Ehitusseadmed
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
18.04.2022
Põhitekst
07.11.2008
Põhitekst
EN 74-2 specifies: - materials; - design requirements; - specified values for resistances and stiffnesses which a coupler has to achieve under test; - test procedures and assessment; for the following special couplers: - screw or wedge half couplers, sleeve couplers with shear studs, right angle reduction couplers and swivel reduction couplers. It gives recommendations for on-going production control. These couplers are for use principally in temporary works. . Each coupler is able to be fixed to at least one side to one 48,3 mm diameter steel or aluminium tube. For the other side of reduction couplers, this standard specifies requirements for the diameter and wall thickness of tubes. For testing, screw couplers are tightened with a torque of 50 Nm and wedge couplers are tightened with a 500 g hammer until the jarring blow. Other special half couplers such as half couplers attached by riveting, used mainly for members of prefabricated scaffolds, are outside the scope of this European Standard.
*
*
*
PDF
19,32 € koos KM-ga
Paber
19,32 € koos KM-ga
Sirvi standardit: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN 74-3:2007

Couplers, spigot pins and baseplates for use in falsework and scaffolds - Part 3: Plain base plates and spigot pins - Requirements and test methods
Uusim versioon Kehtiv alates 06.06.2007
Põhitekst

EVS-EN 74-1:2005

Couplers, spigot pins and baseplates for use in falsework and scaffolds - Part 1: Couplers for tubes - Requirements and test procedures
Kehtetu alates 18.04.2022
Põhitekst

EVS-EN 12811-3:2003

Temporary works equipment - Part 3: Load testing
Uusim versioon Kehtiv alates 01.03.2003
Põhitekst

EVS-EN 12813:2004

Temporary works equipment - Load bearing towers of prefabricated components - Particular methods of structural design
Uusim versioon Kehtiv alates 12.10.2004