Tagasi

EVS-EN ISO 13588:2019

Non-destructive testing of welds - Ultrasonic testing - Use of automated phased array technology (ISO 13588:2019)

Üldinfo
Kehtiv alates 15.03.2019
Alusdokumendid
ISO 13588:2019; EN ISO 13588:2019
Tegevusala (ICS grupid)
25.160.40 Keevisliited
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
15.03.2019
Põhitekst
06.11.2012
Põhitekst
This document specifies the application of the phased array technology for the semi- or fully automated ultrasonic testing of fusion-welded joints in metallic materials of minimum thickness 6 mm. It applies to full penetration welded joints of simple geometry in plates, pipes, and vessels, where both the weld and the parent material are low-alloy and/or fine grained steel. For the testing of welds in other steel materials this document gives guidance. For coarse-grained or austenitic steels, ISO 22825 applies in addition to this document.
This document provides guidance on the specific capabilities and limitations of the phased array technology for the detection, location, sizing and characterization of discontinuities in fusion-welded joints. Phased array technology can be used as a stand-alone technology or in combination with other non-destructive testing (NDT) methods or techniques, for manufacturing inspection, pre-service and for in-service inspection.
This document specifies four testing levels, each corresponding to a different probability of detection of imperfections.
This document permits assessment of discontinuities for acceptance purposes based either on amplitude (equivalent reflector size) and length, or on height and length.
This document does not include acceptance levels for discontinuities.
This document is not applicable for automated testing of welds during the production of steel products covered by ISO 10893-8, ISO 10893-11 and ISO 3183.
*
*
*
PDF
20,74 € koos KM-ga
Paber
20,74 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 10863:2020

Non-destructive testing of welds - Ultrasonic testing - Use of time-of-flight diffraction technique (TOFD) (ISO 10863:2020)
Uusim versioon Kehtiv alates 15.06.2020
Põhitekst

EVS-EN ISO 15626:2018

Non-destructive testing of welds - Time-of-flight diffraction technique (TOFD) - Acceptance levels (ISO 15626:2018)
Uusim versioon Kehtiv alates 04.09.2018
Põhitekst

EVS-EN ISO 20601:2018

Non-destructive testing of welds - Ultrasonic testing - Use of automated phased array technology for thin-walled steel components (ISO 20601:2018)
Uusim versioon Kehtiv alates 03.01.2019
Põhitekst

EVS-EN ISO 19285:2017

Non-destructive testing of welds - Phased array ultrasonic testing (PAUT) - Acceptance levels (ISO 19285:2017)
Uusim versioon Kehtiv alates 03.10.2017