Skip to main content
Tagasi

EVS-EN ISO 14577-4:2007

Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 4: Test method for metallic and non-metallic coatings

Üldinfo

Kehtetu alates 03.01.2017
Alusdokumendid
ISO 14577-4:2007; EN ISO 14577-4:2007
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
03.01.2017
Põhitekst
04.07.2007
Põhitekst
This part of ISO 14577 specifies a method for testing coatings which is particularly suitable for testing in the nano/micro range applicable to thin coatings. This test method is limited to the examination of single layers when the indentation is carried out normal to the test piece surface, but graded and multilayer coatings can also be measured in cross-section if the thickness of the individual layers or gradations is greater than the spatial resolution of the indentation process. The test method is not limited to any particular type of material. Metallic, non-metallic and organic coatings are included in the scope of this part of ISO 14577. The application of this part of ISO 14577 regarding measurement of hardness is only possible if the indenter is a pyramid or a cone with a radius of tip curvature small enough for plastic deformation to occur within the coating. The hardness of visco-elastic materials, or materials exhibiting significant creep will be strongly affected by the time taken to perform the test.

Nõutud väljad on tähistatud *

*
*
*
PDF
24,40 € koos KM-ga
Paber
24,40 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Muudatus

EVS-EN ISO 5349-2:2001/A1:2015

Mechanical vibration - Measurement and evaluation of human exposure to hand-transmitted vibration - Part 2: Practical guidance for measurement at the workplace (ISO 5349 2:2001/Amd 1:2015)
Uusim versioon Kehtiv alates 02.09.2015
Põhitekst

EVS-EN 10250-1:2000

Open die steel forgings for general engineering purposes - Part 1: General requirements
Kehtetu alates 01.09.2022
Põhitekst

EVS-EN 10250-2:2000

Open die steel forgings for general engineering purpuses - Part 2: Non-alloy quality and special steels
Kehtetu alates 01.09.2022
Põhitekst

EVS-EN 10250-3:2000

Open die steel forgings for general engineering purposes - Part 3: Low alloy special steels
Kehtetu alates 01.09.2022