Tagasi

ISO 10605:2008

Road vehicles -- Test methods for electrical disturbances from electrostatic discharge

Üldinfo
Kehtiv alates 07.07.2008
Tegevusala (ICS grupid)
43.040.10 Elektriseadmed
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
10.04.2014
Muudatus
25.02.2010
Parandus
07.07.2008
Põhitekst
Põhitekst
ISO 10605:2008 specifies the electrostatic discharge (ESD) test methods necessary to evaluate electronic modules intended for vehicle use. It applies to discharges in the following cases: ESD in assembly; ESD caused by service staff; ESD caused by occupants. ESD applied to the device under test (DUT) can directly influence the DUT. ESD applied to neighbouring parts can couple into supply and signal lines of the DUT in the vehicle and/or directly into the DUT. ISO 10605:2008 describes test procedures for evaluating both electronic modules on the bench and complete vehicles. It also describes a test procedure that classifies the ESD sensitivity of modules for packaging and handling. ISO 10605:2008 applies to all types of road vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor). ISO 10605:2008 is based in part on IEC 61000-4-2 and describes vehicle-specific requirements. ISO 10605:2008 does not apply to pyrotechnic modules.
*
*
*
PDF
182,80 € koos KM-ga
Paber
182,80 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

ISO 11452-1:2015

Road vehicles -- Component test methods for electrical disturbances from narrowband radiated electromagnetic energy -- Part 1: General principles and terminology
Uusim versioon Kehtiv alates 02.06.2015
Põhitekst

ISO 11452-2:2019

Road vehicles -- Component test methods for electrical disturbances from narrowband radiated electromagnetic energy -- Part 2: Absorber-lined shielded enclosure
Uusim versioon Kehtiv alates 10.01.2019
Muudatus

ISO 10605:2008/Amd 1:2014

ISO 10605:2008 - Amendment
Uusim versioon Kehtiv alates 10.04.2014
Põhitekst

ISO 7637-3:2016

Road vehicles -- Electrical disturbances from conduction and coupling -- Part 3: Electrical transient transmission by capacitive and inductive coupling via lines other than supply lines
Uusim versioon Kehtiv alates 01.07.2016