Tagasi

ISO 20457:2018

Plastics moulded parts -- Tolerances and acceptance conditions

Üldinfo
Kehtiv alates 28.08.2018
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
28.08.2018
Põhitekst
This document specifies possible manufacturing tolerances for plastic moulded parts. This document specifies all integral features with general tolerances with surface profile tolerance within a specified datum system. It allows for additional specifications in case of functional needs and requirements using the ISO-GPS-tools for dimensional and geometrical tolerating. This document addresses injection moulding, injection compression moulding, transfer moulding, compression moulding and rotational moulding of non-porous moulded parts made from thermoplastics, thermoplastic elastomers and thermosets of thermoplastics. This document is applicable to other plastic processes if agreed to by the contractual parties. Moulded part surface imperfections such as sink marks, undesired flow structures and roughness, as well as joint lines are not addressed in this document. This document is not intended to supplant, replace or in any way interfere with requirements for tolerances found in product standards.
*
*
*
PDF
159,66 € koos KM-ga
Paber
159,66 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

CEN ISO/TS 8062-2:2013

Geometrical Product Specifications (GPS) - Dimensional and geometrical tolerances for moulded parts - Part 2: Rules (ISO/TS 8062-2:2013)
Uusim versioon Kehtiv alates 14.11.2013
Põhitekst

EVS-EN ISO 8062-3:2007

Toodete geomeetrilised spetsifikatsiooni (GPS). Valatud osade mõõtmete osas kehtivad ja lubatud geomeetrilised hälbed. Osa 3: Üldised mõõtmete osas kehtivad ja lubatud geomeetrilised hälbed ja valamisel kehtivad töötlemisnormid
Uusim versioon Kehtiv alates 06.08.2007
Põhitekst

EVS-EN ISO 10135:2009

Geometrical product specifications (GPS) - Drawing indications for moulded parts in technical product documentation (TPD)
Uusim versioon Kehtiv alates 07.08.2009
Põhitekst

EVS-EN ISO 5459:2011

Geometrical product specifications (GPS) - Geometrical tolerancing - Datums and datum systems (ISO 5459:2011)
Uusim versioon Kehtiv alates 06.09.2011