Tagasi

ISO 4386-1:2019

Plain bearings -- Metallic multilayer plain bearings -- Part 1: Non-destructive ultrasonic testing of bond of thickness greater than or equal to 0,5 mm

Üldinfo
Kehtiv alates 16.04.2019
Tegevusala (ICS grupid)
21.100.10 Liugelaagrid
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
16.04.2019
Põhitekst
15.10.2012
Põhitekst
This document specifies an ultrasonic testing method for determining bond defects between the bearing metal and the backing. The test can be performed on metallic multilayer plain bearings consisting of steel- or copper-based material backings lined with bearing metal based on lead and tin, with layer thicknesses greater than or equal to 0,5 mm. For cast iron backings, this document is applicable with restrictions. The ultrasonic signal reflected by the bond interface between the bearing metal and the backing is used to determine bonding defects. Ultrasonic testing is not possible on edge zones of sliding surface, flange sides, joint areas, oil holes, grooves, etc. in a range of less than half the diameter of the ultrasonic probe because of undefined reflections. The same applies to bearings with dovetail keying grooves at the bond. Ultrasonic testing of bond does not apply along the edges of the dovetails. Evaluation of the bond on the visible transition from the backing to the bearing metal (on end faces or joint faces) is only practicable by the penetrant testing method specified in ISO 4386-3. This document only describes in detail the pulse-echo method. Within the meaning of this document, the ultrasonic method only permits a qualitative evaluation of the bonding and not a quantitative determination of the bond strength. The ultrasonic bond test differs only between bond and bond defect.
*
*
*
PDF
67,10 € koos KM-ga
Paber
67,10 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

CWA 17663:2021

Measurement of Worker Satisfaction in Automated Systems - Methodology CEN Workshop Agreement
Uusim versioon Kehtiv alates 15.03.2021
Põhitekst

EVS-EN ISO 10675-1:2021

Non-destructive testing of welds - Acceptance levels for radiographic testing - Part 1: Steel, nickel, titanium and their alloys (ISO 10675-1:2021)
Uusim versioon Kehtiv alates 31.12.2021