Tagasi

prEN 1561

Founding - Grey cast irons

Üldinfo
Kavand
Alusdokumendid
prEN 1561
Tegevusala (ICS grupid)
77.080.10 Malmid
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
Põhitekst
02.11.2011
Põhitekst
This document specifies the properties of unalloyed and low-alloyed grey cast irons used for castings, which have been manufactured in sand moulds or in moulds with comparable thermal behaviour. NOTE This document can also be applicable to grey cast irons cast in permanent moulds, provided the related cast samples are casted under the same conditions as the castings. This document specifies the characterizing properties of grey cast irons by either a) the tensile strength of cast samples, b) if agreed by the manufacturer and the purchaser, the tensile strength of samples cut from a casting, c) the hardness determined on the castings or on a cast-on knob. If agreed by the manufacturer and the purchaser, the combination of both tensile strength from option a) and hardness from option c) may be specified. This document specifies six grades of grey cast iron by a classification based on tensile strength determined on machined test pieces prepared from cast samples (see Table 1) and six grades of grey cast iron by a classification based on Brinell hardness (see Table 2). This document does not cover technical delivery conditions for iron castings; see EN 1559-1 [3] and EN 1559-3 [4]. This document does not apply to grey cast irons used for pipes and fittings according to EN 877 [5].
*
*
*
PDF
12,60 € koos KM-ga
Paber
12,60 € koos KM-ga
Standardi monitooring