Tagasi

prEN ISO 2566-2

Steel - Conversion of elongation values - Part 2: Austenitic steels (ISO/FDIS 2566-2:2021)

Üldinfo
Kavand
Alusdokumendid
ISO/FDIS 2566-2; prEN ISO 2566-2
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
Põhitekst
01.01.2000
Põhitekst
This document specifies a method of converting room temperature percentage elongations after fracture obtained on various proportional and non-proportional gauge lengths to other gauge lengths. Formula (1), on which conversions are based, is considered to be reliable when applied to austenitic stainless steels within the tensile strength range 450 to 750 N/mm2 and in the solution treated condition. These conversions are not applicable to: a) cold reduced steels; b) quenched and tempered steels; c) non-austenitic steels. These conversions are not applicable when the gauge length exceeds 25 0S or where the width to thickness ratio of the test piece exceeds 20.
*
*
*
PDF
9,90 € koos KM-ga
Paber
9,90 € koos KM-ga
Standardi monitooring