Skip to main content
Back

EVS-EN ISO 286-2:2010

Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)

General information

Valid from 04.10.2010
Base Documents
ISO 286-2:2010; EN ISO 286-2:2010; ISO 286-2:2010/Cor 1:2013; EN ISO 286-2:2010/AC:2013
Directives or regulations
None

Standard history

Status
Date
Type
Name
09.09.2013
Corrigendum
04.10.2010
Main + corrigendum
This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and  es (for shafts), and the lower limit deviations EI (for holes) and ei (for shafts) (see Figures 1 and 2). The ISO system for tolerances on linear size provides a system of tolerances and deviations suitable for features of the following types: a) cylinders; b) two parallel opposite surfaces. For simplicity, and also because of the importance of cylindrical workpieces of circular section, only these are referred to explicitly. It should be clearly understood, however, that the tolerances and deviations given in this part of ISO 286 equally apply to workpieces of other than circular sections. In particular, the term “hole” or “shaft” is used to designate features of the cylinder type (e.g. for the tolerancing of the diameter of a hole or shaft) and, for simplicity, these terms are also used for two parallel opposite surfaces (e.g. for the tolerancing of the thickness of a key or the width of a slot). For further information on terminology, symbols, the basis of the system, etc., see ISO 286-1.

Required fields are indicated with *

*
*
*
PDF
31.72 € incl tax
Paper
31.72 € incl tax
Browse standard from 2.44 € incl tax
Standard monitoring

Customers who bought this item also bought

Main + corrigendum

EVS-EN ISO 286-1:2010

Geometrical product specifications (GPS) - ISO code system for tolerances of linear sizes - Part 1: Basis of tolerances, deviations and fits (ISO 286-1:2010)
Newest version Valid from 06.07.2010
Main

EVS-EN 22768-2:2007

General tolerances - Part 2: Geometrical tolerances for features without individual tolerance indications (ISO 2768-2:1989)
Withdrawn from 15.03.2021
Main

EVS-EN ISO 17450-3:2016

Geometrical product specifications (GPS) - General concepts - Part 3: Toleranced features (ISO 17450-3:2016)
Newest version Valid from 05.07.2016
Main

EVS-EN ISO 17450-4:2018

Geometrical product specifications (GPS) - Basic concepts - Part 4: Geometrical characteristics for quantifying GPS deviations (ISO 17450-4:2017)
Newest version Valid from 15.02.2018