Back

IEC 61643-12:2020

Low-voltage surge protective devices - Part 12: Surge protective devices connected to low-voltage power systems - Selection and application principles

General information
Valid from 07.05.2020
Directives or regulations
None
Standard history
Status
Date
Type
Name
07.05.2020
Main
13.11.2008
Main
IEC 61643-12:2020 describes the principles for the selection, operation, location and coordination of SPDs to be connected to 50/60 Hz AC power circuits, and equipment rated up to 1 000 V RMS. These devices contain at least one non-linear component and are intended to limit surge voltages and divert surge currents. NOTE 1 Additional requirements for special applications are also applicable, If required. NOTE 2 IEC 60364 and IEC 62305-4 are also applicable. NOTE 3 This standard deal only with SPDs and not with surge protection components (SPC) integrated inside equipment. This third edition cancels and replaces the second edition published in 2008. This edition constitutes a technical revision. NOTE The following differing practice of a less permanent nature exists in the USA: In the USA, SPDs tested to Class I tests are not required. This exception applies to the entire document. This edition includes the following significant technical changes with respect to the previous edition: a) Scope: Deleted reference to 1 500 V dc b) Added or revised some definitions c) Added new clause 4 on Need for protection d) Added new information on disconnecting devices e) Revised Characteristics of SPD f) Revised List of parameters for SPD selection g) Added new information on Measured Limiting Voltage e) Added or revised some Annexes
*
*
*
PDF
322.14 €
Standard monitoring