Skip to main content
Tagasi

EVS-EN 61180:2016

High-voltage test techniques for low-voltage equipment - Definitions, test and procedure requirements, test equipment

Üldinfo

Kehtiv alates 06.12.2016
Alusdokumendid
IEC 61180:2016; EN 61180:2016
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
06.12.2016
Põhitekst
01.01.2003
Põhitekst
01.01.2003
Põhitekst
IEC 61180:2016 is applicable to dielectric tests with direct voltage; dielectric tests with alternating voltage; dielectric tests with impulse voltage and test equipment used for dielectric tests on low-voltage equipment. This standard is applicable only to tests on equipment having a rated voltage of not more than 1 kV a.c. or 1,5 kV d.c. This standard is applicable to type and routine tests for objects which are subjected to high voltage tests as specified by the technical committee. The test equipment comprises a voltage generator and a measuring system. This standard covers test equipment in which the measuring system is protected against external interference and coupling by appropriate screening, for example a continuous conducting shield. Therefore, simple comparison tests are sufficient to ensure valid results. This standard is not intended to be used for electromagnetic compatibility tests on electric or electronic equipment. Tests with the combination of impulse voltages and currents are covered by IEC 61000-4-5. This standard provides the relevant technical committees as far as possible with:
- defined terms of both general and specific applicability;
- general requirements regarding test objects and test procedures;
- methods for generation and measurement of test voltages;
- test procedures;
- methods for the evaluation of test results and to indicate criteria for acceptance;
- requirements concerning approved measuring devices and checking methods and measurement uncertainty. Alternative test procedures may be required and these should be specified by the relevant technical committees. Care should be taken if the test object has voltage limiting devices, as they may influence the results of the test. The relevant technical committees should provide guidance for testing objects equipped with voltage limiting devices. This 1st edition of IEC 61180 cancels and replaces the 1st edition of IEC 61180-1, issued in 1992, and the 1st edition of IEC 61180-2, issued in 1994.
Key words: High Voltage Test Techniques, Dielectric Tests, Disruptive Discharge, Withstand Voltage.

Nõutud väljad on tähistatud *

*
*
*
PDF
26,84 € koos KM-ga
Paber
26,84 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN IEC 63474:2023

Electrical and electronic household and office equipment - Measurement of networked standby power consumption of edge equipment
Uusim versioon Kehtiv alates 01.08.2023
Põhitekst

EVS-EN 60990:2016

Puutevoolu ja kaitsejuhivoolu mõõtemeetodid
Uusim versioon Kehtiv alates 04.10.2016
Põhitekst

EVS-EN 60695-11-10:2013

Tuleohukatsetused. Osa 11-10: Katseleegid. 50 W horisontaal- ja vertikaalleegiga katsetamise meetodid
Uusim versioon Kehtiv alates 07.10.2013
Põhitekst

EVS-EN IEC 60695-2-12:2021

Fire hazard testing - Part 2-12: Glowing/hot-wire based test methods - Glow-wire flammability index (GWFI) test method for materials
Uusim versioon Kehtiv alates 01.12.2021