Skip to main content
Tagasi

EVS-EN ISO 11124-4:2018

Preparation of steel substrates before application of paints and related products - Specifications for metallic blast-cleaning abrasives - Part 4: Low-carbon cast-steel shot (ISO 11124-4:2018)

Üldinfo

Kehtiv alates 16.10.2018
Alusdokumendid
ISO 11124-4:2018; EN ISO 11124-4:2018
Tegevusala (ICS grupid)
25.220.10 Haaveldus
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
16.10.2018
Põhitekst
01.01.2000
Põhitekst
This document specifies requirements for 12 grades of low-carbon cast-steel shot abrasive, as supplied for blast-cleaning processes. Values are specified for hardness, density, defect/structural requirements and chemical composition.
The requirements specified in this document apply to abrasives supplied in the "new" condition only. They do not apply to abrasives either during or after use.
Test methods for metallic blast-cleaning abrasives are given in the various parts of ISO 11125.
Low-carbon cast-steel shot abrasives are used in both static and site blasting equipment. They are most often selected where a facility exists for recovery and re-use of the abrasive.
NOTE 1 Information on commonly referenced national standards for metallic abrasives and their approximate relationship with ISO 11124 is given in Annex A.
NOTE 2 Although this document has been developed specifically to meet requirements for preparation of steelwork, the properties specified will generally be appropriate for use when preparing other material surfaces, or components, using blast-cleaning techniques. These techniques are described in ISO 8504-2.

Nõutud väljad on tähistatud *

*
*
*
PDF
12,20 € koos KM-ga
Paber
12,20 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring