Tagasi

EVS-EN ISO 21304-2:2021

Plastics - Ultra-high-molecular-weight polyethylene (PE-UHMW) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties (ISO 21304-2:2021)

Üldinfo
Kehtiv alates 01.02.2021
Alusdokumendid
ISO 21304-2:2021; EN ISO 21304-2:2021
Tegevusala (ICS grupid)
83.080.20 Termoplastid
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
01.02.2021
Põhitekst
07.11.2008
Parandus
01.04.2000
Põhitekst
This document specifies the methods of preparation of test specimens and the test methods to be used in determining the properties of PE-UHMW moulding and extrusion materials. It gives the requirements for handling test material and for conditioning both the test material before moulding and the specimens before testing. This document gives the procedures and conditions for the preparation of test specimens and procedures for measuring properties of the materials from which these specimens are made. Properties and test methods which are suitable and necessary to characterize PE-UHMW moulding and extrusion materials are listed. The properties have been selected from the general test methods in ISO 10350-1. Other test methods in wide use for or of particular significance to these moulding and extrusion materials are also included in this document, as are the designatory properties specified in ISO 21304-1. This document specifies the materials with MFR less than 0,1 g/10 min at 190 °C /21,6 kg based on ISO 17855-1. The methods of preparation and conditioning, the specimen dimensions and the test procedures specified in this document are used in order to obtain reproducible and comparable test results. Values determined will not necessarily be identical to those obtained using specimens of different dimensions or prepared using different procedures.
*
*
*
PDF
15,01 € koos KM-ga
Paber
15,01 € koos KM-ga
Hind: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN ISO 1133-1:2011

Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 1: Standard method (ISO 1133-1:2011)
Uusim versioon Kehtiv alates 04.01.2012
Põhitekst

EVS-EN ISO 1628-1:2009

Plastics - Determination of the viscosity of polymers in dilute solution using capillary viscometers - Part 1: General principles
Uusim versioon Kehtiv alates 03.04.2009
Muudatus

EVS-EN ISO 1628-1:2009/A1:2012

Plastics - Determination of the viscosity of polymers in dilute solution using capillary viscometers - Part 1: General principles - Amendment 1 (ISO 1628-1:2009/Amd 1:2012)
Uusim versioon Kehtiv alates 05.09.2012
Põhitekst

EVS-EN ISO 179-1:2010

Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
Uusim versioon Kehtiv alates 04.10.2010