Skip to main content
Tagasi

EVS-EN ISO 1133-1:2011

Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 1: Standard method (ISO 1133-1:2011)

Üldinfo

Kehtetu alates 15.07.2022
Alusdokumendid
ISO 1133-1:2011; EN ISO 1133-1:2011
Tegevusala (ICS grupid)
83.080.20 Termoplastid
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
15.07.2022
Põhitekst
04.01.2012
Põhitekst
Põhitekst
EVS-EN ISO 1133:2005
This part of ISO 1133 specifies two procedures for the determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastic materials under specified conditions of temperature and load. Procedure A is a mass-measurement method. Procedure B is a displacement-measurement method. Normally, the test conditions for measurement of melt flow rate are specified in the material standard with a reference to this part of ISO 1133. The test conditions normally used for thermoplastics are listed in Annex A. The MVR is particularly useful when comparing materials of different filler content and when comparing filled with unfilled thermoplastics. The MFR can be determined from MVR measurements, or vice versa, provided the melt density at the test temperature is known. This part of ISO 1133 is also possibly applicable to thermoplastics for which the rheological behaviour is affected during the measurement by phenomena such as hydrolysis (chain scission), condensation and crosslinking, but only if the effect is limited in extent and only if the repeatability and reproducibility are within an acceptable range. For materials which show significantly affected rheological behaviour during testing, this part of ISO 1133 is not appropriate. In such cases, ISO 1133-2 applies.

Nõutud väljad on tähistatud *

*
*
*
PDF
24,40 € koos KM-ga
Paber
24,40 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 1133-2:2011

Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 2: Method for materials sensitive to time-temperature history and/or moisture (ISO 1133-2:2011)
Uusim versioon Kehtiv alates 04.01.2012
Põhitekst

EVS-EN ISO 179-1:2010

Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
Kehtetu alates 03.07.2023
Põhitekst

EVS-EN ISO 527-2:2012

Plastid. Tõmbeomaduste määramine. Osa 2: Vormitud ja ekstrusiooni teel saadud plastide teimimise tingimused (ISO 527-2:2012)
Uusim versioon Kehtiv alates 04.04.2012
Muudatus

EVS-EN 50520:2020/A1:2021

Cover plates and cover tapes for the protection and location warning of buried cables or buried conduits in underground installations
Uusim versioon Kehtiv alates 01.10.2021