Tagasi

EVS-EN ISO 179-1:2010

Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test

Üldinfo
Kehtiv alates 04.10.2010
Alusdokumendid
ISO 179-1:2010; EN ISO 179-1:2010
Tegevusala (ICS grupid)
83.080.01 Plastid üldiselt
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
1.1 This part of ISO 179 specifies a method for determining the Charpy impact strength of plastics under defined conditions. A number of different types of specimen and test configurations are defined. Different test parameters are specified according to the type of material, the type of test specimen and the type of notch. 1.2 The method can be used to investigate the behaviour of specified types of specimen under the impact conditions defined and for estimating the brittleness or toughness of specimens within the limitations inherent in the test conditions. It can also be used for the determination of comparative data from similar types of material. 1.3 The method has a greater range of applicability than that given in ISO 180[1] and is more suitable for the testing of materials showing interlaminar shear fracture or of materials exhibiting surface effects due to environmental factors. 1.4 The method is suitable for use with the following range of materials: - rigid thermoplastic moulding and extrusion materials (including filled and reinforced compounds in addition to unfilled types) and rigid thermoplastics sheets; - rigid thermosetting moulding materials (including filled and reinforced compounds) and rigid thermosetting sheets (including laminates); - fibre-reinforced thermosetting and thermoplastic composites incorporating unidirectional or multi-directional reinforcements (such as mats, woven fabrics, woven rovings, chopped strands, combination and hybrid reinforcements, rovings and milled fibres) or incorporating sheets made from pre-impregnated materials (prepregs), including filled and reinforced compounds; - thermotropic liquid-crystal polymers.
*
*
*
PDF
15,01 € koos KM-ga
Paber
15,01 € koos KM-ga
Hind: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

EVS-EN ISO 527-2:2012

Plastid. Tõmbeomaduste määramine. Osa 2: Vormitud ja ekstrusiooni teel saadud plastide teimimise tingimused (ISO 527-2:2012)
Uusim versioon Kehtiv alates 04.04.2012
Muudatus

EVS-EN ISO 179-2:2000/A1:2012

Plastics - Determination of Charpy impact properties - Part 2: Instrumented impact test - Amendment 1: Precision data (ISO 179-2:1997/Amd 1:2011)
Kehtetu alates 15.06.2020
Põhitekst

EVS-EN ISO 1133-1:2011

Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 1: Standard method (ISO 1133-1:2011)
Uusim versioon Kehtiv alates 04.01.2012
Põhitekst

EVS-EN ISO 294-5:2013

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2011)
Kehtetu alates 02.01.2018