Tagasi

EVS-EN ISO 21970-2:2019

Plastics - Polyketone (PK) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties (ISO 21970-2:2019)

Üldinfo
Kehtiv alates 16.09.2019
Alusdokumendid
ISO 21970-2:2019; EN ISO 21970-2:2019
Tegevusala (ICS grupid)
83.080.20 Termoplastid
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
16.09.2019
Põhitekst
02.11.2018
Põhitekst
This document specifies the methods of preparation of test specimens and the standard test methods to be used in determining the properties of thermoplastic polyketone moulding and extrusion materials. Requirements for handling test material and/or conditioning both the test material before moulding and the specimens before testing are given. The properties have been selected from the general test methods in ISO 10350-1. Other test methods in wide use for or of particular significance to these moulding and extrusion materials are also included in this document, as are the designatory properties specified in ISO 21970-1. It is intended that the methods of preparation and conditioning, the specimen dimensions and the test procedures specified in this document be used in order to obtain reproducible and comparable test results. Values determined will not necessarily be identical to those obtained using specimens of different dimensions or prepared using different procedures.
*
*
*
PDF
9,61 € koos KM-ga
Paber
9,61 € koos KM-ga
Hind: 2,40 € koos KM-ga
Standardi monitooring
Teised on ostnud veel
Põhitekst

ISO 16365-2:2014

Plastics -- Thermoplastic polyurethanes for moulding and extrusion -- Part 2: Preparation of test specimens and determination of properties
Uusim versioon Kehtiv alates 28.04.2014
Põhitekst

EVS-EN ISO 3672-2:2002

Plastics - Unsaturated-polyester resins (UP-R) - Part 2: Preparation of test specimens and determination of properties
Uusim versioon Kehtiv alates 05.03.2002
Põhitekst

EVS-EN ISO 3673-2:2012

Plastics - Epoxy resins - Part 2: Preparation of test specimens and determination of properties of crosslinked epoxy resins (ISO 3673-2:2012)
Uusim versioon Kehtiv alates 05.09.2012
Põhitekst

EVS-EN ISO 294-5:2017

Plastics - Injection moulding of test specimens of thermoplastic materials - Part 5: Preparation of standard specimens for investigating anisotropy (ISO 294-5:2017)
Uusim versioon Kehtiv alates 02.01.2018