Skip to main content
Tagasi

EVS-EN ISO 6145-8:2008

Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 8: Diffusion method

Üldinfo

Kehtiv alates 07.10.2008
Alusdokumendid
ISO 6145-8:2005; EN ISO 6145-8:2008
Tegevusala (ICS grupid)
71.040.40 Keemiline analüüs
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
07.10.2008
Põhitekst
This part of ISO 6145 specifies a dynamic method using diffusion for the preparation of calibration gas mixtures containing component mole fractions ranging from 10^−9 to 10^−3. A relative expanded uncertainty of measurement, U, obtained by multiplying the relative combined standard uncertainty by a coverage factor k = 2, of not greater than ± 2 % can be achieved by using this method. By keeping the path between the diffusion source and place of use as short as possible, the method can be applied for the generation of low-concentration calibration gases of organic components that are liquid at room temperature, with boiling points ranging from about 40 °C to 160 °C. This part of ISO 6145 is applicable not only for the generation of calibration gas mixtures of a wide range of hydrocarbons at ambient and indoor air concentration levels, but also for the generation of low-concentration gas mixtures of water.

Nõutud väljad on tähistatud *

*
*
*
PDF
19,52 € koos KM-ga
Paber
19,52 € koos KM-ga
Sirvi standardit alates 2,44 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

EVS-EN ISO 6145-1:2008

Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 1: Methods of calibration
Kehtetu alates 01.11.2019
Põhitekst

EVS-EN ISO 6145-10:2008

Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 10: Permeation method
Uusim versioon Kehtiv alates 07.10.2008
Põhitekst

EVS-EN ISO 6145-11:2008

Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 11: Electrochemical generation
Uusim versioon Kehtiv alates 07.10.2008
Põhitekst

EVS-EN ISO 6145-4:2008

Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 4: Continuous syringe injection method
Uusim versioon Kehtiv alates 07.10.2008