Tagasi

ISO 10350-2:2020

Plastics -- Acquisition and presentation of comparable single-point data -- Part 2: Long-fibre-reinforced plastics

Üldinfo
Kehtiv alates 22.07.2020
Tegevusala (ICS grupid)
83.120 Tugevdatud plastid
Direktiivid või määrused
puuduvad
Standardi ajalugu
Staatus
Kuupäev
Tüüp
Nimetus
22.07.2020
Põhitekst
17.02.2011
Põhitekst
ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions or along different directions in the material. The properties included are those presented conventionally in manufacturers' data sheets. This document applies to reinforced thermoplastic and thermosetting materials where the reinforcement fibres are either discontinuous with a fibre length prior to processing greater than 7,5 mm or continuous (e.g. fabric, continuous-strand mat or unidirectional). ISO 10350-1 deals specifically with unreinforced and filled plastics, including those using fibres less than 7,5 mm in length.
*
*
*
PDF
64,06 € koos KM-ga
Paber
64,06 € koos KM-ga
Standardi monitooring