Tagasi

ISO 13318-3:2004

Determination of particle size distribution by centrifugal liquid sedimentation methods -- Part 3: Centrifugal X-ray method

Üldinfo
Kehtiv alates 08.07.2004
Direktiivid või määrused
puuduvad

Standardi ajalugu

Staatus
Kuupäev
Tüüp
Nimetus
08.07.2004
Põhitekst
ISO 13318-3:2004 describes a method for determining the particle size distributions of homogeneous particulate material using centrifugal sedimentation in a liquid. Solids concentrations are determined by the attenuation of an X-ray beam. The resulting signal enables conversion to a particle size distribution.
The method of determining the particle size distribution described in this standard is applicable to powders which can be dispersed in liquids or powders which are present in slurry form. The typical particle size range for analysis is from 0,1 m to 5 m. The method is applicable to powders in which all particles have the same effective density, chemical composition and comparable shapes. Materials possessing elements with an atomic number greater than about 12 can be expected to produce adequate X-ray opacity. Particles should not undergo chemical or physical change in the suspension liquid. It is necessary that the particles have a higher density than that of the liquid.
*
*
*
PDF
82,61 € koos KM-ga
Paber
82,61 € koos KM-ga
Standardi monitooring

Teised on ostnud veel

Põhitekst

ISO 13318-1:2001

Determination of particle size distribution by centrifugal liquid sedimentation methods -- Part 1: General principles and guidelines
Uusim versioon Kehtiv alates 01.03.2001
Põhitekst

ISO 17867:2015

Particle size analysis -- Small-angle X-ray scattering
Kehtetu alates 05.10.2020
Põhitekst

ISO 13318-2:2007

Determination of particle size distribution by centrifugal liquid sedimentation methods -- Part 2: Photocentrifuge method
Uusim versioon Kehtiv alates 18.09.2007
Põhitekst

ISO 22412:2017

Particle size analysis -- Dynamic light scattering (DLS)
Uusim versioon Kehtiv alates 06.02.2017